All trailers with electric brakes are required to have a breakaway switch to apply the brakes if the trailer becomes disconnected from the tow vehicle. Many older trailers do not come equipped with a breakaway switch. If you own an old trailer, it's easy to install a breakaway switch. Purchase a kit that contains the switch, a battery and a battery box. For trailers that already have an on-board battery, a breakaway switch kit is not necessary.
Instructions
1. Select a location to mount the trailer breakaway switch. It should be located on the trailer tongue with the cable facing forward; the cable must be able to be pulled straight. Mount the switch to the trailer with a self-drilling screw through the hole in the mounting tab.
2. Mount the battery box inside the trailer frame in a protected location. The battery is equipped with four 5/16-inch holes, but it is only necessary to use two of them. Install the mounting bolts diagonal from each other. Position the box and mark the holes, then remove the box and drill the holes. If the trailer has an on-board battery, skip this step.
3. Install a solderless ring terminal on the breakaway battery's negative wire. Scrape the paint from a small area near the battery box. Attach the ring terminal to the bare spot with a self-drilling screw.
4. Connect one lead of the trailer breakaway switch to the breakaway battery's positive wire. Perform the splice with a solderless butt connector. If necessary, extend this wire with 14-gauge automotive primary wire and solderless butt connectors. Tape all connections with electrical tape. If the trailer already has an on-board battery, it is only necessary to extend the wire from the breakaway switch to the battery's positive terminal.
5. Locate the trailer connector's blue wire that supplies power to the electric brakes. You may have to cut into the trailer wiring's sheathing to find the wire. Connect the breakaway switch's other lead to the blue wire with a Scotchlok connector. If necessary, extend the wire from the trailer breakaway switch with 14-gauge automotive primary wire and solderless connectors.
6. Test the breakaway switch by pulling on the cable until the insulating tab is removed from the switch. The trailer brakes should lock up. Make sure to put the insulating tab all the way back in the switch after performing this test.
Tips Warnings
Charge the breakaway battery periodically. Test the battery every few weeks to determine if it needs to be charged.
Related Posts:
Replace The Lid Switch On A 70 Series Kenmore Washer
Kenmore 70 Series washing machines are top-loading residential units. The washing machine has a switch that detects whether the lid is open or closed and pauses the washing machine when the lid is...
Build Sides For A Utility Trailer
Build Sides for a Utility TrailerUtility trailers are just that -- trailers used for a variety of purposes, from hauling limbs and debris to carrying lawn tractors and all-terrain vehicles. Utilit...
Attach A Tension Wire To A Chainlink Fence
Chain-link fence with a vinyl coating is available in several colors to either blend into its surroundings or provide extra visibility.Adding tension wire to a chain-link fence provides stability...
Test The Pressure Switch On A Whirlpool Duet
Ohm meterThe Whirlpool Duet washer uses a water pressure switch to determine how much water to let into the tub. The switch also will detect any issues with oversudsing or overfilling. When you re...
Finance A Travel Trailer With Poor Credit
Buying a travel trailer will give your family affordable vacations.Your credit score is poor. Your debt to income ratio is higher than it should be, you have missed a couple of payments on your mo...
