Recovering the small lampshades on chandeliers gives them new life.
A chandelier can add sparkle, drama and elegance to any room in your home, and can often be found inexpensively at a flea market or thrift store. These finds might be a bit ragged-looking and could use some updating. Chandeliers often have small lampshades that become faded and worn with time; these shades are easily updated by recovering them with a new and fresh fabric that will give new life to you chandelier and d cor.
Instructions
1. Remove the lampshades from your chandeliers. Place your tissue paper on a flat surface, like the kitchen counter. Place your lampshade on its side on the tissue paper with the seam side down. Roll the shade to the right until it makes a complete rotation. Trace the upper edge as it rotates; it will make a u shape as it rotates.
2. Roll the lampshade back to its starting position and repeat rolling the shade to the right, this time tracing the lower edge of the shade; it will make another u shape, this one below the one you previously made. Use a ruler to connect the two edges of the u shaped lines.
3. Use your ruler to draw seam allowances 1 inch outside of each of the lines you drew. Each of the four lines should be extended out another inch. Cut out this pattern from the tissue paper and hold it up to your lampshade to make sure it fits. Make any adjustments you need to the pattern.
4. Pin your pattern to your fabric and cut it out. Fold one short edge of the fabric over 1/2 inch and press in place with your finger.
5. Spray your lampshade liberally with the spray adhesive. Starting with the raw short edge of your fabric, press your fabric to the seam of the shade. Roll the fabric onto your shade slowly and carefully to make sure no wrinkles or air bubbles occur; if they do, pull the fabric away from the shade and smooth the fabric back into place.
6. Roll the fabric onto the shade until the folded edge is smoothed into place. One-half-inch of raw fabric will hang from both the top and bottom of the shade. With your scissors, cut small clips into the fabric from the edge of the fabric up to the edge of the lampshade.
7. Place a line of glue on the underside of the lampshade on the top and bottom edges. Smooth the clipped edges onto the glued section of the lampshade and hold in place for about 30 seconds. Hold edges in place with butterfly clips. Let dry completely and remove clips. Glue trim in place if desired.
Related Posts:
Recover Lamp Shades
Lamps are standard fixtures in most homes. Rather than buy new lamps every time you change the color scheme in your home, you can re-cover the lamps you already have. A homemade lampshade is easy...
Make Your Own Fabric Roller Shades From Vinylshade
Vinyl window shades may say boring more than any other window treatment, but add fabric to these boring shades and your decor instantly becomes customized. In one afternoon, you can give a plain r...
Recover Vinyl Roller Shades
Fabric can be used to recover a vinyl roller shade.Vinyl roller shades provide light control and privacy, and are an inexpensive decorating option for any room in your home. V...
Recover Your Lampshade Using Ribbon
Recover Your Lampshade Using RibbonBring new life to an old lampshade with colorful strands of ribbon. You can find old lampshades at thrift stores and yard sales; as long as you like the shape an...
Cover Window Shades With Fabric
Custom window treatments can break your decorating budget, but it's cost efficient to cover window shades with fabric. You'll get a custom designer look for a fraction of the cost.Instructions1. U...
