Some residential homes have shower temperature restrictors installed on the hot water volume or control knob. This little component tucked behind the cover plate is positioned so the user cannot turn the hot water control or volume knob past a certain point. This is a safety device to prevent accidental scalding from occurring. However, if you turn the temperature down in your water heater, you will have to remove the temperature restrictor to have hot water in the shower.
Instructions
1. Shut off the water supply line to your shower at the dedicated shut-off valve or by turning the main water supply to the home off.
2. Remove the cover plate on the hot water control by inserting a flathead screwdriver between the plate and the wall and popping it off. The cover plate will dangle loosely around the hot water knob stem.
3. Look for a collar with two nuts or nubs around the stem of the hot water volume knob. One nub or nut will be pointed straight up in the 12 o'clock position.
4. Grasp the nub or nut pointing upward with needle-nose pliers and unfasten it. Remove it from the hot water knob. Or you can turn it clockwise until it is in the desired position. The more you turn the nut or nub clockwise, the more hot the water will become when using the shower.
5. Replace the cover plate by popping it back in place, then turn the water supply back on. Test the hot water in your shower thereafter. You can adjust the restrictor as necessary to achieve the temperature you are most comfortable with.
Related Posts:
Remove Eljer Shower Faucet Handles
Eljer contracts complete solutions for home remodels, specializing in plumbing related needs such as showers and faucets. Many of their products are actually built by other manufacturers and then...
Remove A Tub & Shower Valve Diverter
The tub and shower diverter can be removed to replace worn washers.A diverter directs water from one place to another. In a bathroom, the shower and tub diverter directs water either to the shower...
Remove A Shower Faucet Sleeve
The shower trim sleeve is a cylindrical-shaped part that fits over the cartridge and bonnet nut on the main body of the faucet. The part's job is mainly to cover the cartridge cosmetically and als...
